NXP Cortex-A9 i.MX6 CPU MODULE/SoM/Core-board (FET- i.MX6DL)
- Model: i.MX6 DL
- CPU: i.MX6Dual Lite
- Architecture: Cortex-A9
- RAM: 1G DDR3 1066
- Flash: 8GB eMMC
- Main Frequency: 1GHz
- OS: Android, Linux
|
i.MX6 CPU Module |
|||
|
CPU |
Freescale i.MX6Q/DL processor |
I2C |
3-ch |
|
Architecture |
Cortex-A9 |
SPI |
2-ch |
|
Main Frequency |
1GHz |
CAN |
2×CAN |
|
RAM |
1GB DDR3 1066 |
USB HOST |
1×USB2.0 |
|
FLASH |
8GB eMMC |
USB DEVICE |
1×OTG2.0 |
|
Input voltage |
4.2V |
SD/MMC/SDIO |
2×SD/MMC |
|
2D/3D |
Support |
Ethernet |
1-ch Gb Ethernet port |
|
Audio |
IIS interface |
MiniPCIE |
1-ch |
|
PMU |
MMPF0100NPEP |
UART/IrDA |
5-ch(1 debug port is included) |
|
Size |
60mm*60mm |
EINT/GPIO |
support |
|
Connection Method |
Stamp holes |
Video Codec |
Hardware codec |
|
OS |
Android4.4/Linux3.0.35/Ubuntu12.04 |
HDMI |
1-ch |
|
LCD |
RGB24bit(2-ch 8bit LVDS interface) |
Camera |
1×5MP parallel camera |
|
Graphic controller |
Vivante GC355/VIVANTE GC320 |
SATA |
1(SATA-II)(Only support quad core processor now) |
|
i.MX6 Base board |
|||
|
Audio |
3-ch(1-ch phone,1-ch MIC,1-ch speaker) |
User key |
3 |
|
I2C |
2-ch |
Boot switch |
Set to boot from Nandflash or SD card |
|
SPI |
1-ch |
Reset |
1 |
|
CAN |
1-ch |
PWM |
1-ch（For LCD backlight） |
|
RS485 |
1-ch (With isolation protection ) |
LCD |
1-ch,support 7-inch capacitive LCD |
|
Camera |
1-ch,5MP parallel camera, OV5640 |
EINT |
support |
|
SD/MMC/SDIO |
2-ch,(1-ch SD/MMC card slot) |
GPIO |
support |
|
USB HOST |
1-ch, support USB 2.0 protocol |
LVDS |
2-ch |
|
USB DEVICE |
1-ch, support USB 2.0 protocol |
HDMI |
1-ch |
|
Ethernet |
1-ch gigabit Ethernet interface, RG45 connector |
lithium battery |
Support 2 lithium/polymer batteries. |
|
Serial |
4-ch (1 for debug port, 2-ch 3-wire serial, 1-ch 5-wire serial port) |
SATA |
1 (3.5-inch hard disk is available only when 12V power is connected)（For quad core available） |
|
IrDA receiver |
1 |
||
|
Power jack |
One 12V constant voltage power jack |
GPS |
1,VK1613S3M5 module, SIRF3,with external antenna |
|
RTC |
support |
3G |
Support 3G module with mini-PCIE interface, SIM card slot is on the backside of the baseboard. |
|
ADC |
5-ch, in which 4-ch are used for resistive touch, 1-ch is used for voltage detection |
WIFI&BT |
1,RealTekRTL8723ASCombo ModuleIEEE802.1 1b/g/n 2.4GHz 1T1RWiFiwith Bluetooth v2.0+EDR/Bluetooth 3.0/3.0+HS/4.0 |